11:24 PM Sat 6 Mar 2010 GMT
|
|
'Prop shaft'
.
|
When was the last time you had the propeller shaft checked on your sailing boat? How old are your engine mounts? Have you replaced your cutlass bearing recently? Do I sound like your mother?
Well, if she were here, she'd be giving you some important advice! Both sailing boats and powerboats with inboard engines generally have rubber in the engine mounts, packing material in the stuffing box and a cutlass bearing in the propeller strut.
Of course, there is always a shaft to which the propeller is attached. On recreational boats that get only weekend and occasional vacation trip use, total hours of operation are often low and inboard driveline elements are sufficiently simple and robust that they can last for years without failure.but there is always wear.
You don't need a broken drive shaft to spoil your day. Constant vibration, heat and noise may be dampening your fun every time the boat is run. It comes down to accurate alignment in the drive train. When things are all on spec, the boat will be at its smoothest and quietest. Plus, it will be a touch more economical and a lot longer lived. You really don't want to suffer that broken shaft.
So, give them the shaft!
|
|
Prop 250 - .. .
|
Start the process by having your marine engineer verify that the shaft is straight and has no visible wear spots. A good shaft can be trued up, but one that has been run bent or out of alignment for several seasons, can be ready to snap from fatigue.
Even a very small amount of damage can start a chain reaction of problems. Also, the shaft itself is a large and heavy piece that has to be checked when it is outside the boat. Dropping the shaft requires the coupler between the transmission and the stuffing box to be undone and often the rudder and stock have to be removed to slide the shaft out. It slides out of the stuffing box and through the cutlass bearing in the strut before it's free.
This is not a simple DYI project because separating the coupler and sliding it out often requires special tools. An amateur with a pry bar can do real damage.
Start the driveline checking process with the shaft because even a minor issue with the shaft can cause noise and vibration problems and if you try to fix those by adjusting engine mounts, you will spend a fair bit of money without fixing your vibration problem.
While you are pulling the shaft, send out your props to be checked for accuracy and balance. You don't need to hit the shoal to hurt a prop and start noise and vibration there.
How often should you do this? When you notice a problem of course, but the subtle progress of wear means that every few years, it's worth the modest investment in checking!
by Canadian Yachting/Sail-world Cruising
Click on thumbnails to enlarge and find more photos:
|
