I have a couple fins which could do with some TLC, but I am not sure the best way to repair the dings and scratches mainly around the bottom and leading edge without changing the fin forever.
I am sure I read a post on this a couple of years ago but I'll be damned if I can find it again.
How do the fin experts on this forum do it?
Note anything that requires more than 10 minutes sanding is out because that is about my attention span when sanding, and that means I will be sanding an anchor.

Hey Geoff,
car spray filler for the scratches then wet and dry sandpaper. Epiccraft white filler for the dings.

Just wipe it down with metho to get off the grease and salt.

What colour is that gel Ian ? I have all G10 fins now and have been using epoxy to fill nicks and chips, but its not quite the same colur as G10

I have a wonderful fin unfortunately dumb me I pounded it into the fin box with a hard object to make it snug but took off a 1.5cm chunk off it at the trailing edge..Do I have to leave it at that or does it cause hydro problems. Am thinking of just epoxy glue and sand it down but never had the mindset to do it yet

Also for the second query another fin has a broken edge off the trailing edge about .5cm wide and deep how does one fill that up? it's too thin!