NSW
382 posts
Hi
Can anyone advise how to change the leader lines on an old Naish Carbon bar?
The bar is still good but I need to change the leader lines and cannot see how to dismantle the bar ends.
They are moulded rubber and slip over the ends of the bar without screws?
WA
9106 posts
Yeah i think i know the ones.
recently renovated my old Naish bar that i got with an old Aero kite.
what i found was i had to cut the rubber bar ends off, there probably is a simpler way to do it, but thats what i did.
i then went to SOS in Freo and picked up new bar ends reasonably cheap, and threaded the leader lines through these before putting them on the bar.
its a real pain in the arse.
WA
142 posts
The rubbers just fit tight on the bar.
Just pull the old ones off,and to install the new ones,use a little washing up detergent,to make then slip on.
The new rubbers are readilly available.
