Hey guys,
Just got a pair of 2012 Ronix ones, and keen to use them, though the board i am using for the moment has spacings about 2-3 mil longer than the 6 inch ronix spacing (see pic). So i was thinking about drilling out 1 mil each side of the boot on the baseplate, anyone else done this before and is there a better way?

Heres a pic, the spacings are probably 2-3 mil wider than the boots spacings.


Heres a pic of the baseplate, i want to drill a hole through the outer side of the white semi circular spacings.

On older boots I would say yes, but on these I think it would compromise the strength a bit. However I'm sure it would work if you did it right.

LiveToFly said...
You can get T bolts for your board from a wake shop

Don't think wake shops sell them, but you can buy them at a hardware store or at bunnings. A nut and bolt place at Southport, Goldcoast used to have stainless ones but they are pretty hard to come by.

Go to ya local Ronix guy and get a set of (2008)spacer rings and dril them.Did something slimer on a old LF Concept with 7.5 spred and work fine for the 2 months i ran it.


No good will come form ****ing with ya boots.Youll snap the baseplate then you ankle.