Hey Blaster,

Your back lines are too short. All lines should be of equal length with the bar pulled in to within two inches of the chicken loop and the depower strap set at full depower.

If it is an Airush Bar, it will be easy to adjust all the lines and get them right with minimum fuss. We usually use a screw driver in the ground with all the pigtails larks headed onto the screw driver then adjust the lines until they are all even and when setup as mentioned above.

It should make no difference if the front lines split from the bar or midway to the kite. This sounds like a modified bar as Airush front lines don't split midway, It should make no diff though. If you have trouble bring the kite to us and I will help you sort it out in 10 minutes.

Good winds,

Hey Blaster,

Using the same bar and lines will be OK as long as you are aware trhan a longer bar will make the 10 turn a lot faster than the 14m, thats why we use smaller bars with smaller kites.

The 5th line should be fine so long as the 5th line section which attaches to the kite is not part of one long line from the bar.

If you can imagine the radius of the curve of the 14m Flow is a lot bigger than the 10m which will require shortening the overall 5th line length. if you have 5 lines of equal length and then connect the 5th to an extension piece to the kites centre attach point, it should be fine. Just add an extension to the 10m as well and leave it attached to the 10m, that way you can swap kites and use the same bar.

Good winds,

Make sure you 'Y' on the 14 is not too close and pulls our front tips in,iv had that prob before