Can Props Be Repaired

> 10 years ago
Reply
Register to post, see what you've read, and subscribe to topics.
Toph
Toph
WA
1887 posts
WA, 1887 posts
8 Feb 2015 11:45am
Well Folks, as the title asks.
I don't think much more needs to be explained, it should be fairly self explainitty to why I ask Needless to say a nice weekend was cut short.


LooseChange
LooseChange
NSW
2140 posts
NSW, 2140 posts
8 Feb 2015 7:23pm
Bit hard to know how to respond to your post without knowing more of the details.

Given that no information was offered as to the type of mishap you had I'll go out on a limb here and say "yes" the prop can be repaired.

Now it could well be that that the cost of the repair will be more than the cost of a replacement prop, but the answer given still stands.
Toph
Toph
WA
1887 posts
WA, 1887 posts
8 Feb 2015 5:29pm
Thanks LooseChange.

So basically, the answer is yes, but your curious in what happened...... Fair enough.

In a narrow, small and crowded bay with reef to the north. 20kts southerly blowing. We were a few metres off the reef approaching an area just starting to open up a bit. I know the bay reasonably well. For some reason still yet to be determined, at that point I had a steering issue. That and with the southerly I drifted north and knicked a bommie. 2 blades broken about half way down. Luckily no (well very little) hull damage. Could've been worse.

Thanks for the answer in any case, and I think you're right. Having done a bit more research after my intial post, it is probably cheaper to just replace it.
LooseChange
LooseChange
NSW
2140 posts
NSW, 2140 posts
8 Feb 2015 9:51pm
The initial response I gave was a bit tongue in cheek, naughty of me to do that to what was obviously a serious incident.

I assume the prop is fixed blade and you were under power at the time.

With two blades gone it is technically possible to to rebuild, assuming you get someone to take on such a daunting task, often what is technically possibly doesn't mean that it practical to do it and as you have surmised, replacement in this case is the going to be the cheaper and technically superior option.
Toph
Toph
WA
1887 posts
WA, 1887 posts
8 Feb 2015 7:03pm
LooseChange said..
The initial response I gave was a bit tongue in cheek, naughty of me to do that to what was obviously a serious incident.

I assume the prop is fixed blade and you were under power at the time.

With two blades gone it is technically possible to to rebuild, assuming you get someone to take on such a daunting task, often what is technically possibly doesn't mean that it practical to do it and as you have surmised, replacement in this case is the going to be the cheaper and technically superior option.


No worries LooseChange, as we all know, it is impossible to hear the tone hence sometimes the meaning of the written word. Unless it is plainfully obvious, I don't take much said here to heart and will assume most people are having a little bit of a banter. This is by far one of the kinder forums I visit (even HW).

As for the incident, it wasn't as serious as it sounds. Just an expensive nuisance
LooseChange
LooseChange
NSW
2140 posts
NSW, 2140 posts
8 Feb 2015 10:23pm
The conditions you describe could very easily have turned serious and being (up the creek) without propulsion is not a nice situation to be in.
Glad it didn't go more pear shaped for you.
Please Register, or first...
Topics Subscribe Reply