NSW
441 posts
I'm planning to re-deck (non-slip) the Kona but would like to know what the skin is made of, it's ASA which means bugger all to me. Is ASA epoxy resin over fibreglass?
WA
15105 posts
I think it means its plastic. Does it have a seam running around the edge of the board?
WA
23688 posts
ASA is a plastic, but is not as bad as polyethylene/ polypropylene (like the old wally boards were) which nothing would stick to.... you have half a chance with ASA.
Google surface preparation for ASA and epoxy resins
VIC
1580 posts
I have regripped ASA boards before and haven't found them any different to an epoxy board.
Just sand back slightly, mask off, then a thin coast of uv stable anything. I have used epoxy resin, polyester resin and recently as described in another thread polyeurothane spray (cabothane). Each time I sprinkle caster sugar evenly, by using a shaker. remove masking tape before it fully dries. The spray seems surprisingly good with how grippy it is in water,as it feels quite smooth when dry.
NSW
441 posts
Thanks for the info guys.
