Hi just had a failure of a twin pulley block on my 2008 revolver set up is 1:1
i have some spare ronstan pulleys that i think i can use to replace them
is this possible or will i need to get the twin pulleys previously installed.
I dont think the rear attachment pigtail will be affected at all or if so only slightly.

The twin pulleys are required for the 2:1 set up but i dont use it so some feed back would be great.

Also has anyone had the problem of the larks head knot comming off the rear line attaching point in the 1:1 set up mode
thanks in adavance
saul