Just replaced the trimcord and cleat setup on my bandit but the new line set up is different has anyone done this before , Carnt figure out how to remove the old lines going through the back of the clamp/ stopperball etc. SAFETY FIRST.

yeah had the same problem haha. remove the u-clamp at the top and the screw in the stopper ball with a hex key. you also have to remove the knot where the 2 centrelines become that single line.

The ring on the 5th line is larks headed onto the ring - stumped me for ages and even considered cutting it but you can actually just unloop it from itself.

Bit complicated - don't think i explained it well but give me a PM. am more than happy to give you a hand with it sometime if you can't work it out

thecrownjulz said...

yeah had the same problem haha. remove the u-clamp at the top and the screw in the stopper ball with a hex key. you also have to remove the knot where the 2 centrelines become that single line.

The ring on the 5th line is larks headed onto the ring - stumped me for ages and even considered cutting it but you can actually just unloop it from itself.

Bit complicated - don't think i explained it well but give me a PM. am more than happy to give you a hand with it sometime if you can't work it out

I dont have a 5th line but managed to work out a system that looks ok.
PS look at the warning above this post if your out at pinns tomo.