Hey just wonderin if anybody has sucsessfully and safely worked out a way to boat launch and recover 4 a session.

Im living on Hamilton Island in the whitsundays and there is no beach on the island to kite off with a consistant breeze and safe downwind area but we have plenty of wind almost all year round.

this is the way i do it from a tinny.
-inflate the kite and lay out and connect your lines on the beach.
-leave the lines connected at the kite, and roll them on the bar until you get to the kite
-put a rubber band around each end of the bar to keep the lines from unwrapping
-deflate the leading edge
-lay the bar and lines carefully in the kite, and roll it up

when you are anchored inflate the leading edge and slowly feed the lines out while keeping all tension on the 5th line only. once the lines are all out jump in the water and water relaunch like normal.

to land
-kite up to the boat and drop the board in first.
-then drift to the leeward side, and either climb into the boat and ditch the kite, or or hang on with one hand and drop the kite first.

make sure you take your time, and check everything at least twice.
when you are launching be ready to ditch the rig quickly if things go wrong (ie no leash and hand ready to hit the chicken loop QR).

Hi WWS,

Here's a thought. Rig the kite with lines on, then deflate the LE. Roll the kite up with lines on, then place it in the boat with your harny around the inflated struts to keep it all together whilst in transit.

Now, grab a bucket and put it in the boat next to your kite. Leave 6 feet (2m) o lines from the kite out free and then start feeding all the lines into the bucket from the kite end running to the bar. Allow the lines to lay on top of each other as they feed into the bucket. Keep the bar outside of the bucket.

Drive to your launch spot and use a stern anchor. Inflate the kite over the bow of the boat and secire it to the boat by a piece of wool which will break with a little bit of a tug. Next, attach your leash and CL and jump over the side of the boat, swimming across the wind window away from the kite. Once you get roughly in position, a couple of good tugs will break the wool tuft and the kite will be able to be launched as per a normal water relaunch.

voila! This method is guaranteed not to tangle and there will be no stress on launch. Give it a go. A little bit of setup time required, but worthwhile.

I'd say forget about the turbo launcher. I've never known anyone to say anything good about them. Usually comments like "waste of money".

Good winds,

not trying to pimp this but
There is full segment on ben Wilsons wave instructional SMACK _ if you are interested.
Shows you how to do it setting the kite up to pumping and lauching.
Forget the turbo launcher - too complicated
- Ben uses the a different method to what has been described here already - work s a treat

Have a look at the videos here and you'll see how the launcher actually works yourself: http://www.kitelauncher.com/. It's pretty straight forward, and often the guy using the turbo is the first to launch as you dont have to walk your lines at all. They are much easier than the bucket method if launching from boat. Just takes a few practices to get it down pat. Also great for launching in areas where there are lots of debris, or with limited setting up space.