My list goodness
this years list
Rigging and halyards
fridge bench top
Finish stove/sink bench top
run fuel piping from tank to stove
Fit the anchor winch and chain system
Non skid deck paint
make my forward cabin saloon doors( ex window shutters) and draw front
add more forward cabin lighting off existing loom.
tidy my wiring near batteries and Isolator .
Run a permanent wiring loom for solar panels( cabin roof) from the MPPT controller under the hatch cover and secure the main sheet track at the same time
go sailing till next winter

Next years list

Refurbish a Bukh DV24 for installing next winter
winter western port
remove old Bukh DV20 and clean paint out the bilge and fit PSS seal
Install the Bukh DV24
Fit new seacocks for the head
fit a hull through for sink drain hose
finish off the interior
apply Sikens to all timber bite work on deck

if there time do some on 2017 winters list
2018 retirer go sailing up the coast for a endless summer

My "To Do" list is always being re-prioritised as I find different things that need doing.

- Finish the other half of the deck with Non slip (Kiwigrip)
- Install Auto pilot - Coursemaster did me a deal at the Boat Show
- Paint the mast & then get it on the boat - all new standing & running rigging, lights, aerial etc.
- Install more winches
- Timber edging for gunwale strip
- Heaps of small stuff = re plumb both toilets to holding tank, Install extra bilge pump, Washer / wiper to windscreen, Rope locker under cockpit step, Switch block for Spreader; Running; Flood lights; - run wires, etc, etc, etc

2015 (only about 16 weekends left til December!):

1. Install new dodger (95% complete)
2. Lay vinyl floor planks ala DAMA's faux teak and holly stylings (requires preps and mods)
3. ... Who am I kidding? All my jobs take 5 to 10 times as long as I think they will so that'll be it.
4. Go sailing and try to have a life besides boat stuff.
5. Oh, and DIY a 1st draft bimini for seats on aft rail using the old dodger frame.
6. Oh, and modify current cockpit shade to account for new stack pack.
7. Keep diving hull to try to extend time to next haul out

2016
1. Scrape back old antifoul. Con$ider repainting.
2. Design and build DIY self steering system
3. Address battery capacity / solar charging inadequacies.
4. Gunwale strip timber. (send me a pic of your edge Lazzarae - interested to know if it's similar and how you're approaching it)

Emotional roller coaster. Overwhelmed now. Must avoid the forum for a while.

Currently getting covers re-done. Then I think I am finished

Oh who am I kidding. If it's on a boat, then it's on the list

Ekkk that does not look like a fun job mc naughty .....I have dug many rotten timbers and wet rotting laminates in the past it's like a cancer! It is pleasing to get it replaced with some marine ply and epoxy laminates though. I replaced the entire cabin sole on my last yacht and my previos power boat!

p.s if it's not structural or causing greif you can always cover it up and sort it in the future!

Snazzy cockpit table!