Hi Guys, I have (had) an EZ-Plug aftermarket handle on my board until this afternoon. Luckily, the drop to the ground was only small, and onto sand, but I need to fix it back on.
What is the best adhesive to puth this right. I believe the original fixture is sticky pads. Does anyone know where I can get these, or is there some more suitable glue I could use ?
Also my board (Oxbow Cruiser) has some wear and tear and some small dings around the rails. I've patched them with UV cure, but want to get the board looking like she should do, Does anyone know a repairer they could reccomend in the Cronulla area who can repair - including colour matching - SUP's. Alternatively, what is the best way to do this myself, I would be keen to have a go if I had a good idea how to make it look good.
Finally, I have a tiny chip on my paddle, should I use UV cure on this, It's a carbon Oxbow.
Cheers guys for any advice.
Jase.

Thanks DJ, I'll get busy with the araldite. Both ends of the handle came off, so I'll clean them up and stick it back on.
My paddle is carbon fibre, just worried about the chip. Its at the point where the shaft meets the blade, om the edge.

One of the best glassers in the country is at Force 9 in Cronulla. Great with tints, etc. Try phoning first to ask if they will work with Epoxy.

Cajun Longboards at Taren Point specialise in epoxy and do great work. Speak to Shannon he will sort you out.

I have sent you an sms too Jason !