Spacing of board racks too far apart.

4 years ago
Reply
Register to post, see what you've read, and subscribe to topics.
N8W
N8W
5 posts
N8W N8W
5 posts
8 Feb 2022 9:04am
Hi everyone,

I know there are lots of questions about how close board racks can be.
BUT

My question is, is there a spacing that is too wide that would then put stress on the Centre of the board because it it isn't being supported in the middle? I would add this relates to a 10'6 long board SUP

Thanks.

*edit*

Sorry guys I was meaning transporting. Space between rear roof rack and Ute/truck tray rack is 6'. Would that much space between the racks put strain on the middle of the board?
Mark _australia
Mark _australia
WA
23737 posts
WA, 23737 posts
8 Feb 2022 9:28am
I doubt it - compared to a 100kg person standing on it that is no stress at all.
Maybe if its nose and tail and you leave it in 45deg with the sun on it all the time....
A foot in from each end and normal temps it should be fine
LeeD
LeeD
3939 posts
3939 posts
8 Feb 2022 9:28am
Usually racks are covered with pipe insulation which flexes to account for v or deep concave like Tom Carroll boards
LeeD
LeeD
3939 posts
3939 posts
8 Feb 2022 9:30am
I like storing SUP's on it's rail, instead of flat. Easier for old guys.
N8W
N8W
5 posts
N8W N8W
5 posts
8 Feb 2022 10:33am
Mark _australia said..
I doubt it - compared to a 100kg person standing on it that is no stress at all.
Maybe if its nose and tail and you leave it in 45deg with the sun on it all the time....
A foot in from each end and normal temps it should be fine


Hi Mate I was thinking there would be a difference due to the water still giving it Support. Not like being suspended in the air.
colas
colas
5393 posts
5393 posts
8 Feb 2022 5:02pm
N8W said..
Sorry guys I was meaning transporting. Space between rear roof rack and Ute/truck tray rack is 6'. Would that much space between the racks put strain on the middle of the board?


No issue, the forces from the (small) weight of the middle of the board are negligible compared to the forces generated by wind buffeting the board and bumps in the road, especially since they tend to rotate the board (a bump lifts the front then the rear), and the most important issue becomes torque forces on the board.

And for this, the larger the space between the bars, the better. Just picture putting the bars close together, the slightest torque will rip the bars off the roof and may even create pressure dents in the board.
Please Register, or first...
Topics Subscribe Reply